Product Code: SZS-A1031Fluid Type: Primer AerosolColour: BlackPackaging: 400g
Black Etch Primer has been designed to provide superior adhesion to metals that are difficult to bond to. Black Etch Primer provides high performance corrosion protection and is a suitable base for a range of top coats. A fast dry product, Black Etch Primer is suitable for use on; gates, fences, railings, pipes and gutters. Black Etch Primer dries to a matt black finish.
Black Etch Primer is suitable for use on: gates, fences, railings, pipes and gutters.
Suitable Surfaces: Aluminium, galvanised iron, new steel, stainless steel, ZINCALUME®, alloys, copper and brass.
Aluminium, galvanised iron, new steel, stainless steel, ZINCALUME®, alloys, copper and brass.
Between 10°C and 40°C. Avoid use in windy conditions.
Etch Primer should not be applied to existing painted surfaces. Surface should be clean, dry and free from contaminants such as; rust, oil, grease, dirt and salt. Thoroughly sand new metal surfaces to ensure maximum adhesion and wipe down thoroughly with acetone. For aged or lightly rusted surfaces remove loose rust with a wire brush, scraper or mechanical sander and wipe down thoroughly with acetone.
Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball begins to rattle. Shake can occasionally during use. Hold can upright approximately 20-25cm from the surface. Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy coat. Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical setting to spray across.
Approximately 2m2 per can (depending on the surface and amount of overspray).
Touch dry in 10 minutes (25°C). Recoat after 2 hours. Drying will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.
Prevent blocking by holding the can upside down and spraying until only clear gas escapes. Also wipe spray tip of nozzle clean. Clean up wet paint with, acetone or general purpose thinner.
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store in well-ventilated place.
Dispose of contents/container according to regional regulations.
From our 10,000+ sq ft operation in Nerang, we support individual workshop jobs, larger commercial sharpening requirements and ongoing tooling needs throughout Queensland and Northern NSW.