Product Code: SZS-A1020Fluid Type: Zinc AerosolColour: blackPackaging: 400g
Black Zinc is a fast drying epoxy based black zinc coating which provides excellent adhesion, corrosion resistance and long lasting durability to metal surfaces. It can be used as an anti-corrosive primer and top coat in a one-step application. It can also be used as a touch up coating for welded areas on galvanised products, however for longer term protection and highly corrosive conditions Grey Zinc is recommended before the application of Black Zinc as a finish coat.
It can also be used as a touch up coating for welded areas on galvanised products, however for longer term protection and highly corrosive conditions Grey Zinc is recommended before the application of Black Zinc as a finish coat.
Suitable Surfaces: Steel, wrought iron, galvanised iron and non-ferrous metals such as; aluminium, alloys, Zincalume® and stainless steel with appropriate primer.
Steel, wrought iron, galvanised iron and non-ferrous metals such as; aluminium, alloys, Zincalume® and stainless steel with appropriate primer.
Between 10°C and 40°C. Avoid use in windy conditions.
Surface should be clean, dry and free from contaminants such as rust, oil, grease, dirt and salt. Welds should be ground back to clean white metal. Thoroughly sand new metal and lightly sand previously painted surfaces to ensure maximum adhesion. Remove loose rust and flaking paint with a wire brush, scraper or mechanical sander. For best results, always remove rust back to bare metal. For superior protection and adhesion on mild steel surfaces and welds it is recommended to prime with G r e y Z i n c and allowing it to dry for 4-6 hours before applying 2 coats of Black Zinc. For non-ferrous metals such as aluminium, alloys, Zincalume® and stainless steel use Grey Zinc.
Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball begins to rattle. Shake can occasionally during use. Hold can upright approximately 20-25cm from the surface. Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy coat. Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical setting to spray across.
Approximately 2.5m² per can (depending on the surface and amount of overspray).
Touch dry in 20 minutes (25°C). Recoat after 1 hour. Hard dry in 16-24 hours. Drying will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.
Prevent blocking by holding the can upside down and spraying until only clear gas escapes. Also wipe pray tip of nozzle clean. Clean up wet paint with mineral turpentine, xylene or general purpose thinner.
Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
Dispose of contents/container according to regional regulations.