Product Code: SZS-A1040Fluid Type: Zinc AerosolColour: Bright SilverPackaging: 400g
Bright Silver Zinc is a barrier type anti-corrosive silver paint, designed to match the bright metallic lustre finish of ‘Hot Dip’ galvanising. Bright Silver Zinc has excellent adhesion properties and provides a tough and durable finish on steel and iron. Although primarily designed for ferrous metals, the product can be used to provide a Bright Silver finish on other substrates. Bright Silver Zinc is ideal for use as a top coat over Grey Zinc.
Primarily for ferrous metals, can also be used to provide a Bright Silver finish on other substrates. Bright Silver Zinc is ideal for use as a top coat over Grey Zinc.
Suitable Surfaces: Steel, iron and non-ferrous metals with appropriate primer.
Steel, iron and non-ferrous metals with appropriate primer.
Between 10°C and 40°C. Avoid use in windy conditions.
Surface should be clean, dry and free from contaminants such as rust, oil, grease, dirt and salt. Welds should be ground back to clean white metal. Thoroughly sand new metal and lightly sand previously painted surfaces to ensure maximum adhesion. Remove loose rust and flaking paint with a wire brush, scraper or mechanical sander. For best results, always remove rust back to bare metal.
For superior protection and adhesion on mild steel surfaces and welds it is recommended to prime with Grey Zinc and allowing it to dry for 4-6 hours before applying 2 coats of Bright Silver Zinc. For non-ferrous metals such as aluminium, alloys, ZINCALUME®, and stainless steel use Grey Zinc.
Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball begins to rattle. Shake can occasionally during use. Hold can upright approximately 20-25cm from the surface. Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy coat. Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical setting to spray across.
Approximately 2m2 per can (depending on the surface and amount of overspray).
Touch dry in 20 minutes (25°C). Recoat after 1 hour. Hard dry in 16-24 hours. Drying will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.
Prevent blocking by holding the can upside down and spraying until clear gas escapes. Also wipe spray tip of nozzle clean. Clean up wet paint with mineral turpentine, xylene or general purpose thinner.
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store in well-ventilated place.
Dispose of contents/container according to regional regulations.