Product Code: SZS-A1090Fluid Type: Zinc AerosolColour: Red OxidePackaging: 400g
Super Red Oxide Primer is a fast dry primer designed to form a tough barrier against corrosion on steel and iron. The primer is ideal for use on; fences, gates, machinery and metal structures. Super Red Oxide Primer provides the ideal base for enamel paints.
The primer is ideal for use on: fences, gates, machinery and metal structures. Super Red Oxide Primer provides the ideal base for enamel paints.
Suitable Surfaces: Steel and iron.
Steel, wrought iron, galvanised iron and non-ferrous metals such as; aluminium, alloys, ZINCALUME® and stainless steel with appropriate primer.
Between 10°C and 40°C. Avoid use in windy conditions.
Surface should be clean, dry and free from contaminants such as rust, oil, grease, dirt and salt. Thoroughly sand new metal and lightly sand previously painted surfaces to ensure maximum adhesion. Remove loose rust and flaking paint with a wire brush, scraper or mechanical sander. For best results, always remove rust back to bare metal.
Before spraying, cover surrounding areas to protect from overspray. Shake can for at least 45 seconds AFTER the mixing ball begins to rattle. Shake can occasionally during use. Hold can upright approximately 20-25cm from the surface. Spray with a smooth sweeping motion. To prevent paint from sagging, apply several light mist coats rather than one heavy coat. Adjust nozzle to achieve desired spray pattern. Use horizontal setting to spray up and down and the vertical setting to spray across.
Approximately 2m2 per can (depending on the surface and amount of overspray).
Touch dry in 15-20 minutes (25°C). Recoat after 30 minutes or after 24 hours. Drying will be slower in cold and humid conditions, in the absence of ventilation or where heavy film build is applied.
Prevent blocking by holding the can upside down and spraying until only clear gas escapes. Also wipe pray tip of nozzle clean. Clean up wet paint with mineral turpentine, xylene or general purpose thinner.
Store locked up. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F. Store in well-ventilated place.
Dispose of contents/container according to regional regulations.
From our 10,000+ sq ft operation in Nerang, we support individual workshop jobs, larger commercial sharpening requirements and ongoing tooling needs throughout Queensland and Northern NSW.